handgun-semi-auto

A semi-automatic pistol is a type of repeating single-chamber handgun (pistol) that automatically cycles its action to insert the subsequent cartridge into the chamber (self-loading) but requires manual actuation of the trigger to actually discharge the following shot. As a result, only one round of ammunition is fired each time the trigger is pulled, as the pistol’s fire control group disconnects the trigger mechanism from the firing pin/striker until the trigger has been released and reset. handgun-semi-auto

Semi-automatic pistols use one firing chamber that remains fixed in a constant linear position relative to the gun barrel. In contrast, although double-action revolvers can also be fired semiautomatically, their rounds are not fired from a single chamber, but rather are fired from each of the chambers that are rotated into linear alignment with the barrel’s position in turn just prior to each shot fired.

Typically, the first round is manually loaded into the chamber by pulling back and releasing the slide mechanism. After the trigger is pulled and the round is fired, the recoil operation of the handgun automatically extracts and ejects the shell casing and reloads the chamber. This mode of operation generally allows for faster reloading and storing of a larger number of cartridges than a revolver.

Where to Buy Semi-Auto Hand Pistol Online

Some modern semi-automatic pistols are double-action-only (DA or DAO); that is, once a round is chambered, each trigger pull cocks the hammer, striker, or firing pin, and additionally releases the same to fire a cartridge in one continuous motion. Each pull of the trigger on a DAO semi-automatic pistol requires the same amount of pressure. The Kel-Tec P-32 is an example of a DAO action. DAO semi-automatic pistols are most generally recommended only in the smaller, self-defense, concealable pistols, rather than in target or hunting pistols. A notable exception is Glock-brand pistols which optimize preset triggers (similar to DAO), but the striker is partially cocked back as the slide closes. This allows for significantly shorter trigger pulls than DAO. The trigger spring can be replaced with a lighter one and paired with a low-strength sear connector resulting in lightened trigger pulls to improve a shooter’s accuracy (like models G34 and G35).

Buy Semi-Auto Hand Gun Online

Smith & Wesson CS45 double-action/single-action← .45 ACP semi-automatic compact pistol
Standard modern semi-automatic pistols are usually double-action (DA), also sometimes known as double-action/single-action (DA/SA). In this design, the hammer or striker may be either thumb-cocked or activated by pulling the trigger when firing the first shot. The hammer or striker is recocked automatically during each firing cycle. In double-action pistols, the first pull of the trigger requires roughly twice as much pressure as subsequent firings, since the first pull of the trigger also cocks the hammer (if not already cocked by hand). The Beretta 92F/FS, a full-sized, service, semi-automatic pistol is an example of this style of action. A common mode of carrying for DA semi-automatic pistols is with the magazine full, a round chambered, and the gun holstered and uncocked with the external safety unengaged or off. The Taurus PT145 is an example of a DA/SA weapon, as it has no decocker and thus has its striker primed from the moment of chambering and only enters double-action mode if a round fails to fire upon the pin’s impact; at other times, it operates as a single-action striker-fired firearm.

In contrast, a single-action (SA) semi-automatic pistol must be cocked by first operating the slide or bolt, or, if a round is already chambered, by cocking the hammer manually. The famed Colt M1911 is an example of this style of action. All SA semi-automatic pistols exhibit this feature and automatically cock the hammer when the slide is first “racked” to chamber a round. A round can also be manually inserted into the chamber with the slide locked back. Then safety can be applied. It is generally not a good idea to load a round manually as this can cause excessive wear on the extractor as semi-automatic firearms were designed to have cartridges loaded from the bottom via the magazine.